Clock - Chevrolet 2013 TRAX Owner's Manual

w x
4. Use to change to the
correct zone number.
5. Press SET/CLR to confirm the
setting.
Recalibrating the Compass
Whenever the DIC or the battery is
disconnected, the compass must be
recalibrated. To do this, the vehicle
must be driven in circles. Only
calibrate the compass in a
magnetically clean and safe
location, such as an open parking
lot, where driving the vehicle in
circles is not a danger. It is
suggested to calibrate away from
tall buildings, utility wires, manhole
covers, or other industrial structures,
if possible.
If code 125 is displayed on the DIC,
the compass needs to be
recalibrated.
Use the DIC buttons to begin
recalibrating the compass:
1. While the vehicle is in P (Park),
press the MENU button to
display the DIC menu.
2. Press and hold SET/CLR while
the Set Cal display is active.
3. Drive the vehicle in tight circles.
The display will begin to flash.
Continue driving in circles for
about 30 seconds. The compass
direction will be displayed.

Clock

Radio Without Touchscreen
The infotainment system controls
are used to access the time and
date settings through the menu
system. See Operation on page 7 8
for information about how to use the
menu system.
Setting the Time and Date
1. Press .
2. Select Set Time or Set Date.
Instruments and Controls
3. Turn the Menu/Tune knob to the
desired value.
4. Press the Menu/Tune knob to
select the value.
5. Turn the Menu/Tune knob to
change the desired value.
6. To save and return to the Time
Settings menu, press
button at any time.
Setting the 12/24 Hour Format
1. Press the .
2. Select Set Time Format.
3. Press the Menu/Tune knob to
select the 12 hour or 24 hour
display format.
Setting the Month and Day
Format
1. Press the .
2. Select Set Date Format.
3. Turn the Menu/Tune knob to the
desired setting.
5-5
BACK