DFI-ITOX G4C600-R User Manual page 86

3
BIOS Setup
3.1.5.12 Resume On LAN
If you are using a LAN card that supports the remote wake up
function, set this field to Enabled. The will allow the network to
remotely wake up a Soft Power Down (Soft-Off) PC. However, if
your system is in the Suspend mode, you can wake up the system
only through an IRQ or DMA interrupt. Refer to "Wake-On-LAN
Connector" in chapter 2 for more information.
3.1.5.13 USB KB Wake-Up From S3
This field, when enabled, allows you to use a USB keyboard to wake
up a system that is in the S3 (STR - Suspend To RAM) state. This
can be configured only if the "ACPI Suspend Type" field is set to
"S3(STR)".
3.1.5.14 Resume By Alarm
Enabled When Enabled, you can set the date and time you
Disabled Disables the automatic power-on function. (default)
3.1.5.15 Date (of Month) Alarm
0
1-31
3.1.5.16 Time (hh:mm:ss) Alarm
This is used to set the time you would like the system to power-on.
If you want the system to power-on everyday as set in the "Date
(of Month) Alarm" field, the time set in this field must be later than
the time of the RTC set in the Standard CMOS Features submenu.
86
would like the Soft Power Down (Soft-Off) PC to
power-on in the "Date (of Month) Alarm" and "Time
(hh:mm:ss) Alarm" fields. However, if the system is being
accessed by incoming calls or the network (Resume On
Ring/LAN) prior to the date and time set in these
fields, the system will give priority to the incoming calls
or network.
The system will power-on everyday according to the
time set in the "Time (hh:mm:ss) Alarm" field.
Select a date you would like the system to power-on.
The system will power-on on the set date, and time set
in the "Time (hh:mm:ss) Alarm" field.