DFI-ITOX G4C600-R User Manual page 77

IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system
BIOS will check the hard disk drive for the
maximum block size the system can transfer. The
block size will depend on the type of hard disk
drive.
Disabled The IDE HDD uses the standard mode.
On-Chip Serial ATA Setting
This section is used to configure the serial ATA drives.
On-Chip Serial ATA
Disabled Disables the onboard Serial ATA.
Auto The system will automatically detect the Serial ATA
drives and set them to the available master/slave
mode.
Manual Select this option to manually configure the Serial ATA
drives in the "Serial ATA Port1 Mode" and "Serial ATA
Port2 Mode" fields.
Serial ATA Port1 Mode and Serial ATA Port2 Mode
These fields are used to select the master/slave mode of the
serial ATA drives. When you select Primary Master, Primary Slave,
Secondary Master or Secondary Slave, make sure they do not
conflict with the settings of the IDE hard drives.
When Logical Primar y is selected, the other por t will
automatically be set to Logical Secondary and vice versa. Logical
Primary or Logical Secondary sets the drives to master mode.
Since both drives are in master mode, the system will not be
able to detect the IDE drives.
RAID Function
If you are configuring RAID on the Serial ATA drives, set this field
to Enabled.
3
BIOS Setup
77