DFI-ITOX G4C600-R User Manual page 42

2
Hardware Installation
aligned with pin 1 of J20. If you are not using this connector,
replace the jumper caps back to their original pin locations. Now
install the card-edge bracket to the system chassis.
Driver Installation
Install the "Audio Drivers". The 3D Audio Configuration software,
which is an audio panel for setting basic audio configurations, will at
the same time be installed into your system. The application program
will allow you to configure 2-channel, 4-channel and 6-channel audio
modes as well as configure the audio effects. Refer to chapter 4 for
more information.
42