Table of Contents
Advertisement
Installing vent Components (Figure 36)
Begin the vent system installation by installing the first component,
90° elbow to the starting collars or straight pipe on the top of the
appliance, then the straight pipe length and then horizontal or
vertical termination kit.
NOTE: All outer connection joints must be sealed with aluminum
tape, screws or silicone sealant rated above 300°F/149°C. The inner
flue joints do not require any sealant.
Page 22
vENT SYSTEM IDENTIFICATION
Figure 36
All vent system components lock into place by sliding the concentric
pipe section with four (4) equally spaced interior beads onto the
appliance collar or previously installed component end with four
(4) equally spaced indented sections. When the internal beads of
each starting outer pipe line up, rotate pipe section clockwise 90°
(approximately 3 inches). The vent pipe is now locked together.
Continue adding components per the pre-planned vent system
configuration. Be certain that each succeeding vent component
is securely fitted and locked into the preceding component in the
vent system.
WALL THIMBLE
(MAXIMUM OF
TWO 90 ELBOWS)
Special venting Components (Simpson Duravent)
See Empire Comfort Systems Retail Price List for Simpson Duravent part
numbers and pricing.
DVVK-4FV
Vertical Flex Vent Kit 4" x 7"
DVVK-4RP
Direct Vent Fireplace Vent Kit For Rear Vent, Thru-the
(DVVK-4R)
wall, 5 to 7 inch wall thickness
DVVK-4RE
Direct Vent Fireplace Vent Kit For Rear Vent, Thru-the-
wall, 5 to 13 3/4 inch wall thickness
DVVK-4TP
Direct Vent Fireplace Vent Kit For Top Vent Thru-the-
(DVVK-4T)
wall, 8 to 11 inch wall thickness
DVVK-4TSP
Direct Vent Fireplace Vent Kit For Top Vent Thru-the-
(DVVK-4TS)
wall, 4.5 to 6 inch wall thickness
DVVK-4VP
Direct Vent Fireplace Vent Kit - Vertical, Flashing Kit w/
(DVVK-4V)
Vertical Cap
VIB6A
Vertical Inlet Baffle Kit For 6 5/8" dia.
VIB7A
Vertical Inlet Baffle Kit For 7" dia.
(MAXIMUM OF
THREE 90 ELBOWS)
DV VENT KITS
26988-3-1012
Advertisement
Table of Contents
