Empire Comfort Systems DVD32FP34N-1 Installation Instructions And Owner's Manual page 12

Flush Wall Installation
Combustible Surround Installation
FINISHED WALL
2 X 4
HEADER
3! OF NON-COMBUSTIBLE MATERIAL
FRONT TRIM OR NON-COMBUSTIBLE
MATERIAL (INSTALLATION IS OPTIONAL)
STAND OFF
Page 12
INSTALLATION (continued)
FINISHED WALL
3! OF NON-COMBUSTIBLE MATERIAL
FRONT TRIM OR NON-
COMBUSTIBLE MA TERIAL
(INSTALLA TION IS OPTIONAL)
JOINT BETWEEN FINISHED
WALL AND UNIT SEALED
WITH 300° F, 149° C SEALANT
MATERIAL (SEALANT IS OPTIONAL)
Figure 12
MANTELSHELF
COMBUSTIBLE SURROUND
JOINT BETWEEN FINISHED WALL AND
UNIT SEALED WITH 300° F 149 ° C
SEALANT MATERIAL (SEALANT IS OPTIONAL)
Figure 13
Attention: Cold climate installation recommendation: When
installing this unit against a non-insulated exterior wall, it is
recommended that the outer walls be insulated to conform to
applicable insulation codes.
vent Runs (Figures 14, 15, 16, 17 and 18)
In planning the installation for the fireplace, it is necessary to install
certain components before the appliance is completely positioned
and installed. These include the direct vent system, gas piping for
the appliance and the electrical wiring.
The appliance can be mounted on any of the following surfaces:
1. A flat, hard combustible (burnable) surface.
2. A raised wooden platform.
3. Four (4) corner supports. (Example: Four (4) concrete masonry
blocks.) These supports must be positioned so they contact all four
(4) perimeter edges on the bottom of the unit.
vERTICAL, 90° ELBOW WITH HORIZONTAL TERMINATION
DVD32, 36
"
47 ½
(121 cm)
TO BOTTOM
OF UNIT
VENTCAP/
THIMBLE
WALL FIRESTOP/
THIMBLE
Figure 14
26988-3-1012