Turn Signal Indicator Lights; High Beam Indicator Light; Headlight Flasher; Daytime Running Light System - Subaru Legacy 2014 Owner's Manual

& Headlight flasher
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the lighting switch is in the
off position.
When the headlights are on high beam,
the high beam indicator light "
combination meter also illuminates.
& Daytime running light system
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the "
is dark outside.
The high beam headlights will automati-
cally illuminate at reduced brightness
when the engine has started, under the
following conditions.
. The parking brake is fully released.
. The light switch is in the off or "
position.
. The light switch is in the "AUTO"
position and the headlights do not turn
on automatically.
. The select lever is in a position other
than the "P" position (AT and CVT mod-
els).
NOTE
When the light switch is in the "
position, the front side marker lights,
tail lights and license plate lights are
" on the
illuminated.
Instruments and controls/Turn signal lever

Turn signal lever

" position when it
To activate the right turn signal, push the
"
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lane change. The turn signal
indicator lights will flash in the direction of
"
the turn or lane change. The lever will
return automatically to the neutral position
when you release it.
3-43