Subaru Legacy 2014 Owner's Manual page 190

! Programming rolling-code-pro-
tected garage door openers in
the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink
Wireless Control System for it by following
steps 1 through 5 in "Garage door opener
programming in the U.S.A." F3-54. Then
continue with the following steps.
NOTE
The assistance of a second person
may make the programming quicker
and easier.
1. Locate the training button on the
garage door opener motor head unit.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,
refer to your garage door opener's instruc-
tion manual.
®
1) Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the "training light" on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink
button that was programmed in the pre-
vious section. Press and release the
button a second time to complete the
programming procedure.
Instruments and controls/Mirrors
NOTE
Some garage door openers may re-
quire you to do the above press-hold-
release sequence a third time to com-
plete the programming.
4. The garage door opener should now
recognize the HomeLink Wireless Control
®
System and your garage door opener
should activate when the HomeLink
button is pressed.
! Programming for entrance gates
and garage door openers in
Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
If any of the HomeLink
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
®
3-55
®
buttons are
®
– CONTINUED –