Subaru Legacy 2014 Owner's Manual page 110

dure too quickly, locking may not have
been completed. After locking the
doors, it is recommended to pull the
REAR door handles to confirm that the
doors have been locked.
. The keyless access function may
not operate properly depending on the
status of the access key and the radio
wave conditions around the vehicle. In
such a case, perform the procedure
described in "Locking and unlocking"
F9-20.
. It is possible to lock the doors even
when one of the doors is open. After
performing the locking procedure,
close the opened door or rear gate to
lock it.
. Within 3 seconds after locking the
doors and the rear gate by using the
keyless access function, it is not
possible to unlock doors and/or the
rear gate by using the keyless access
function.
. When locking, be sure to carry the
access key to prevent locking the
access key in the vehicle.
Keys and doors/Keyless access with push–button start system (Outback – if equipped)
! Unlocking
Carry the access key, and grip the door
handle.
. When the driver's door handle is
gripped, only the driver's door will be
unlocked.
. When the front passenger's door han-
dle is gripped, all doors including the rear
gate will be unlocked.
Also, an electronic chirp will sound twice
and the hazard warning flashers will flash
twice.
! Opening rear gate
1) Rear gate opener button
Carry the access key, and press the rear
gate opener button. Only the rear gate will
be unlocked and opened. Also, an elec-
tronic chirp will sound twice and the
hazard warning flashers will flash twice.
– CONTINUED –
2-15