If You Have Accidentally Triggered The Alarm System; Arming The System - Subaru Legacy 2014 Owner's Manual

2-26
Keys and doors/Alarm system
the system is now activated.
. "ALON" (models with type A combina-
tion meter)
. "AL on" (models with type B combina-
tion meter)
NOTE
You may have the above setting
change done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
! To stop the alarm
Perform any of the following operations.
. Press any button on the access key/
remote transmitter.
. Turn the ignition switch to the "ON"
position.
. Turn the push-button ignition to the
"Acc" position (models with "keyless ac-
cess with push-button start system").
. Carry the access key and press the
rear gate opener button (if equipped).
. Carry the access key and press the
door lock button (if equipped).
& Arming the system
NOTE
. The system can be armed even if the
engine hood, the windows and/or
moonroof are open. Always make sure
that they are fully closed before arming
the system.
. The 30-second standby time can be
eliminated if you prefer. Have it per-
formed by your SUBARU dealer.
. If your vehicle is a Legacy and you
open the trunk using the remote trans-
mitter's " " button with the alarm
system armed, the system will be
temporarily placed in a standby state.
The system will go back to the surveil-
lance state upon locking the trunk.
. The system is in the standby mode
for a 30-second period after locking the
doors with the remote transmitter. The
security indicator light will flash at
short intervals during this period.
. If any of the following actions is
done during the standby period, the
system will not switch to the surveil-
lance state.
– Doors are unlocked using the
remote transmitter.
– Doors are unlocked using the
k e y l e s s a c c e s s f u n c t i o n ( i f
equipped).
– Any door (including the rear gate
(Outback) or the trunk (Legacy)) is
opened.
– The key is inserted into the
ignition switch (models without
"keyless access with push-button
start system").
– Push-button ignition switch is
turned to the "Acc" position (mod-
els with "keyless access with push-
button start system").
! To arm the system using access
key/remote transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition switch to the "OFF"
position (models with "keyless access with
push-button start system").
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood (and
the trunk lid (Legacy)) are locked.
5. Close all doors (and the rear gate
(Outback)).