Subaru Legacy 2014 Owner's Manual page 360

Hide thumbs Also See for Legacy 2014:

Table of Contents

Driving tips/Loading your vehicle

3. Install the bars into the holders.

4. Make sure that the latches are fitted

! How to change the position of the

Carefully read the warning label

attached to the roof rail.

You can change the position of the rear

crossbar. To change the position, perform

the following procedure.

1. Take out the torque wrench from the

jack holder.

2. Undo the cap of the roof rail holder by

using the torque wrench.

3. Undo the bolt of the crossbar by using

the torque wrench.

4. Pull out the crossbar from the roof rail

holder by pulling up the cover.

5. Install the crossbar into the other

6. Tighten the bolt of the crossbar by

using the torque wrench. The tightening

Chapters

Table of Contents

2014 outback