Part Names And Functions - Roland JEWELA JWX-10 User Manual

Part Names and Functions

Front View
Cutter
Cutter holder
Spindle
Collet
Table
Rotary axis unit
Rotary axis unit
Work plate (small)
Angle-adjustment dial
This changes the angle of the ro-
tary axis unit. Each tick of the scale
corresponds to 15 degrees of tilt.
Operation buttons
You use this to switch the sub
power on and off and to move the
tool up and down.
Angle-fixing control
This keeps the rotary axis unit immobile
at the set angle. To change the angle of
the rotary axis unit, pull the control back
toward you.
1-1 About This Machine
Front cover
If you open the front cover, cutting
automatically stops for your safety.
Cutting cannot be restarted even
after you close the front cover.
Sensor
When performing crylindrical cutting,
set the Z origin and the origin point
for the rotary axis unit.
Workpiece chuck
Chucking knob
Chapter 1 Introduction 17