Roland JEWELA JWX-10 User Manual page 47

Sensor cable
2.
Mount the cutter on the spindle.
Make sure the VIEW light is on.
Tip of the
blade
2 to 3 mm
Run the sensor cable around behind the machine to the
top of the table, and connect the sensor cable to the sen-
sor.
Insert the cutter into the spindle.
Cap the tip of the blade and insert it facing up.
Tool retaining screw Tighten the tool retaining screw at a location about 2 to 3
mm above the table.
Hexagonal screw driver
(small)
4-3 Setting the Y-axis Origin for the Rotary Axis Unit
Chapter 4 Feature Reference 45