Roland JEWELA JWX-10 User Manual page 21

Operation panel screen
To make the settings for cutter movement and the cutting-start location, you use the Windows-based driver. To operate
the machine, display the operation panel screen.
X-, Y-, and Z-axis coordinates
These display the present coordinate
values (workpiece coordinate system)
for the X, Y, and Z axes.
Unit of measure-
ment for display
This switches the mea-
surement unit for the
window display to mil-
limeters, inches, or
steps.
Spindle-rotation
This set the rotation of
the spindle.
Spindle-rotation
button
This switches spindle
rotation on and off.
A-axis rotation but-
tons
This display the present
coordinate value
(workpiece coordinate
system) for the A axis.
XYZ movement buttons
These move the spindle in the X,
Y, and Z directions.
Reference-Point Settings
These set the cutting-start location.
You use these to set the origin
point at the selected location and
to detect the selected origin.
1-1 About This Machine
A-axis coordinate
This displays the present coordi-
nate value for the A axis.
Moving to
Specified Location
This moves to the speci-
fied location in a single
step. You can quit mov-
ing by clicking [Stop].
Chapter 1 Introduction
the
19