Getting Ready For Cutting Using The Rotary Axis; Dimensions Of Workpieces Installable And Start Location - Roland JEWELA JWX-10 User Manual

3-2 Getting Ready for Cutting Using the Rotary Axis

Dimensions of Workpieces Installable and Start Location

Dimensions of Workpieces Installable
The cutting area when performing cutting using the rotary axis is as shown below.
The Locations of the Origin Points
When you perform cutting using the rotary axis, you set both the X-axis and the Z-axis origin points. The X origin
becomes the start location for cutting. Set it to match the workpiece you're using. You align the Z origin with the center
of the rotary axis. This means setting it to match the length of the cutter.
When you're creating a cylindrical object there is no special need to set the A origin, but you set it when you want to
specify the start location in the direction of rotation.
The Y origin is automatically set at the center of the rotary axis when the rotary axis unit is installed. If misalignment of
the Y origin is a concern, you can redo the setting.
P.44"Setting the Y-axis Origin for the Rotary Axis Unit ."
30 Chapter 3 Operation
50 mm
Internal circle 15 to 23 mm
Maximum Diameter 85 mm