Part Names - Roland EGX-30 User Manual

3 Part Names

Front
Dust collector hose port
This is where the dust collector
is attached to take up cuttings
while engraving is in progress.
Tool mounting screw
This secures the depth regulator
nose or tool adapter in place.
Table
The table grips the workpiece
to be cut.
Control Panel
(Described on the following
page.)
Rear
Power connector
The power cord included with the
machine connected here.
Removing the Safe-transport Retainers
Safe-transport
Retainers are attached at the locations shown in the
Retainer
figure to ensure safety when transporting this
product.
Use the hexagonal wrench included with the unit to
remove the retainers before use. (Once removed, the
retainers should be stored in a safe place because they
are needed again when repacking the product.)
Depth regulator nose
This is used to attach the
character cutter for engraving
and to adjust the amount of
blade extension.
Tool carriage
Power switch
Parallel connector
A parallel (printer) cable is
connected here.
Serial connector
A serial (RS-232C) cable is
connected here.
9