Clavia Nord Lead 2X User Manual page 79

NORD LEAD 2X V1.0x
Therefore, if you want the sequencer to control the four Slots independently (i.e. not in a layer), make
sure only one of the Slots is active on the Nord Lead 2X (only one Program Slot LED is lit)!
1. Set up the Slots that you plan to use so that they transmit/receive on the desired MIDI Channels. To
set a Slot's MIDI Channel, hold down S
value. See page 67
2. Set the program Slots that you don't plan to use, to MIDI Channel 'oFF'. This is to ensure they
don't play any sound unintentionally.
3. Select the desired Program for each Slot.
4. If your sequencer requires you to transmit on a certain MIDI Channel (the same MIDI Channel as
the Slot receives on), select the desired Slot, before recording.
5. If needed, set the sequencer up to record and play back on the desired MIDI Channel.
6. Activate recording and play the Nord Lead 2X.
7. For an overdub with a new sound, select a new Track with a new MIDI Channel in the sequencer.
P P P P C C C C
R R R R O O O O G G G G R R R R A A A A M M M M H H H H A A A A N N N N G G G G E E E E
For the Nord Lead 2X to transmit and receive Program Change messages, Program Change must be ac-
tivated, see page
• To record a Program Change for a certain Slot, activate recording in the sequencer and simply select a
new Program for the Slot.
• To record a change of Performance, enter Performance mode, activate recording in the sequencer and
select the Performance with the U
When playing back the Performance Program Change message from the sequencer, make sure it gets
transmitted on the Nord Lead's Global MIDI Channel (see
C C C C
O O O O N N N N T T T T R R R R O O O O L L L L L L L L E E E E R R R R S S S S
For the Nord Lead 2X to transmit and receive Control change messages from the front panel this must
be activated, see page
• When you record front panel movements, make sure you have the right Slot activated, and that the
sequencer "echoes" the changes back on the right MIDI Channel, or your changes will affect the
wrong sound!
• If two (or more) Slots are set up to receive on the same MIDI Channel, both will be affected by the
changes!
• Please read the note about Controller transmission in Local Off mode on
for details.
66.
/D
P OWN
66. Modulation Wheel and pedal, however, are always transmitted/received.
10. MIDI: Using Nord Lead 2X with a sequencer
, and press MIDI C
HIFT
buttons.
page 67).
. Then select the Slot, and set the
H
page 66.
Page 77