Clavia Nord Lead 2X User Manual page 28

5. Programming Velocity Sensitivity: Clearing velocity programming for one knob
V1.0x
If you then turn a knob that has been programmed for velocity sensitivity, without holding any buttons
or anything, you will adjust the minimum value only and the maximum value will move with it, accord-
ingly.
If you adjust the value for a parameter programmed for velocity control, you move the
entire velocity control range up/down:
This minimum value will result in this maximum value.
C C C C
L L L L E E E E A A A A R R R R I I I I N N N N G G G G V V V V E E E E L L L L O O O O C C C C I I I I T T T T Y Y Y Y P P P P R R R R O O O O G G G G R R R R A A A A M M M M M M M M I I I I N N N N G G G G F F F F O O O O R R R R O O O O N N N N E E E E K K K K N N N N O O O O B B B B
1. Turn the knob to its lowest value.
2. Press the V
ELOCITY
3. Turn the knob a bit up and then back to its lowest value.
4. Press the V
ELOCITY
the knob.
5. Turn the knob back up to any desired value. When velocity programming is cleared for all knobs,
the V
ELOCITY
C C C C
L L L L E E E E A A A A R R R R I I I I N N N N G G G G A A A A L L L L L L L L V V V V E E E E L L L L O O O O C C C C I I I I T T T T Y Y Y Y P P P P R R R R O O O O G G G G R R R R A A A A M M M M M M M M I I I I N N N N G G G G
To clear all velocity programming, hold down S
Page 26
/M A
ORPH SSIGN
/M A
ORPH SSIGN
/M A LED goes out.
ORPH SSIGN
button.
button again. The Velocity/Morph function is now cleared for
and press the V
HIFT
NORD LEAD 2X
This minimum value
will result in this
maximum value.
/M A
ELOCITY ORPH SSIGN
button.