Clavia Nord Lead 2X User Manual page 29

NORD LEAD 2X V1.0x
M M M M
O O O O R R R R P P P P H H H H I I I I N N N N G G G G
Morphing is a term used to describe a continuous "transfer" between two images, sounds or similar. As
described above, the Velocity/Morph function in Nord Lead 2X is normally controlled by velocity. But
you can route the function to the M
two sounds – morphing!
The only thing you have to do to activate morphing for a sound that's already set up for velocity control
is to press the Mod Wheel destination button until Morph is the only lit indicator:
Push this button...
However, if you are setting up a Morph sound from scratch, we recommend the following procedure:
1. Press the M
OD
2. Make sure the M
3. Set up the Program (sound) as you want it.
4. Move the M
OD
5. Press the V
ELOCITY
way you want it at "the other end" of the Morph.
6. Press the V
ELOCITY
7. Play and move the M
You can also use an Expression pedal for Morphing, see
Please note that the Velocity function in the Filter section can be used even if Morphing is active, so
that a Program can be basically Velocity sensitive even though Morphing is activated.
W
OD
M
...until only the
ORPH
W D
HEEL ESTINATION
W is all the way down.
OD HEEL
W all the way up.
HEEL
/M A button and adjust the knobs so that the Program sounds the
ORPH SSIGN
/M A button again.
ORPH SSIGN
W to try out the effect.
OD HEEL
5. Programming Velocity Sensitivity: Morphing
instead which allows you to continuously fade between
HEEL
LED
is lit.
(S ) button until only the M
HIFT
page 19.
LED is lit.
ORPH
Page 27