Clavia Nord Lead 2X User Manual page 108

13. MIDI implementation: System Exclusive implementation
• If the Sys Ex data for a single Patch is sent upon receiving a Patch Dump Request message, either the Pro-
gram Location or the Edit Buffer will be stored, depending on the Message Type byte in the Request
message. This will also determine where the Patch will be placed when it is sent back to a Nord Lead
2X.
Byte (Hex)
$F0
$33
<Device ID>
$04
$00 to $0A
$00 to $03 or $00-$62
<Patch Data 1>
<Patch Data 2>
<Patch Data 3>
:
<Patch Data 132>
$F7
• If Message Type = 0 (Edit Buffer), the Message Specification can be 0 to 3, corresponding to Patch
Slot buttons A to D.
• If Message Type = 1 to 10, then the Message Specification (00 to 98) corresponds to the Program
Number within the Bank (01 to 99).
P P P P
E E E E R R R R C C C C U U U U S S S S S S S S I I I I O O O O N N N N
This message contains all settings in a Percussion Kit. It is transmitted from the Nord Lead 2X in one of
two cases:
• When a Patch Dump is initiated from the front panel and a Percussion Kit is selected.
• When a valid Patch Dump Request message has been received, specifying a Percussion Kit location or
an Edit Buffer containing a Percussion Kit.
Percussion Kit Patch Dump messages will also be sent if the "Dump All" command is used.
Page 106
Byte (Decimal)
240
51
4
0 to 10
0 to 3 or 0 to 98
247
K K K K P P P P D D D D
I I I I T T T T A A A A T T T T C C C C H H H H U U U U M M M M P P P P
Description
System Exclusive
Manufacturer ID (clavia)
= Global MIDI Channel. 0 to 15 ($0-$F).
Model ID for Nord Lead 2X
Message Type specifies the Bank. 0=Edit Buffer, 1 to 10
=Bank 1 to 10
Message Specification specifies the exact memory location,
see below.
See page 111.
End Of Exclusive
NORD LEAD 2X V1.0x