Denso BHT-604BW User Manual page 133

4.
Use the cursor keys ([▲] [▼]) or numerical keys ([2]
highlight a WEP KEY from 1 to 4, and then press the ENT key.
The screen displays as shown on the right.
[1: KEY SIZE]:
Select 40 (40 bits) or 128 (128 bit).
The highlighted setting is the current setting.
When no encryption key h
[2 : KEY]:
The key size "*" displays.
5.
Use the cursor keys ([▲] [▼]) or numeric
cursor keys ([◄] [►]) to select either 40 (40 b
S elect 40 bit for a 10-digit encryption key.
Select 128 bit for a 26-digit encryption key.
6.
Use the cursor keys ([▲] [▼]) or numerical key ([2]) to highlight [2:
ENT key.
The mode changes to entry mode and the cu
7.
Use the numerical keys
th e ENT ke y.
Hexadecimal notation (0, 1, 2, 3, 4, 5, 6, 7, 8, 9, A, B, C, D, E, F) is used for
the encryption key.
P ress the SF and the B
(n o guidance display) and alphabet entry).
To delete a single character, press the BS key.
Press the C key to delete all entries made.
The existing key can be overwritten, however, cannot be edited or deleted.
The screen on the right shows an example in which "40 bit" has been set
for "WEP KEY1" and the key setting is "ABCDE12345".
as been set, 40 will be highlighted.
al key ([1]) to hi
it) or 128 (128 bit).
rsor displays.
to enter an encryption key and then press
S k ey to change the entry mode (numerical entr
Barcode Handy Terminal
[3] [4] [5]) to
ghlight [1: KEY SIZE], and then use the
KEY], and then press the
y
119