Installing/Removing the
Safety Flag
The installation of the safety flag onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.2.
Installing
1. Install the bracket into the accessory tube located on the back of the seat.
2. Install mounting knob to secure the bracket in place. Securely tighten.
3. Install safety flag into bracket.
Removing
1. Remove the safety flag from the
bracket.
2. Remove the mounting knob that
secures the bracket in place.
3. Remove the bracket from the accessory
tube located on the back of the seat.
Installing/Removing/Using the Walker Holder
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
Part No. 1145807
WARNING
INSTALLATION WARNINGS
45
SECTION 12—ACCESSORIES
Safety Flag
Bracket
Accessory
Tubes
FIGURE 12.2 Installing/Removing the
Safety Flag
Mounting
Knob
Lynx™L-3X