Section 11-Transporting; Transporting The Scooter - Invacare Lynx L-3X Owner's Operator And Maintenance Manual

SECTION 11—TRANSPORTING
SECTION 11—TRANSPORTING
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power off and
remove key from ignition.
DO NOT lift the scooter by the rear shroud - otherwise damage to the scooter may
occur.

Transporting the Scooter

NOTE: For this procedure, refer to FIGURE 11.1 on page 43.
Disassembling
1. Turn power off and remove the key from the ignition.
2. Remove any installed accessories.
3. Remove the seat. Refer to Removing/Installing the Seat on page 27.
4. Remove the batteries. Refer to Removing/Installing the Batteries on page 35.
5. Disconnect the tiller wiring connector from the controller wiring connector
(Detail "A").
6. Hold the seat post with one hand.
7. With the other hand, push the release lever to the rear of the scooter (Detail "A").
8. Lift the seat post to separate the front frame assembly from the rear frame assembly
pins.
9. Fold tiller down to lowest locked position. Refer to Adjusting the Tiller Angle on
page 31.
Assembling
1. Unfold tiller. Refer to Adjusting the Tiller Angle on page 31.
2. Position the rear frame between the curved locking brackets of the front frame
assembly.
3. Hold the seat post and align the curved locking brackets on the front frame assembly
with the rear frame assembly pins.
4. While holding the seat post, slowly lower the front frame assembly onto the rear frame
assembly pins until the release lever locks.
5. Connect the tiller wiring connector to the controller wiring connector.
Lynx™L-3X
WARNING
42
Part No. 1145807