Installing/Removing The Safety Flag; Installing/Removing/Using The Walker Holder - Invacare Lynx L-4 Owner's Operator And Maintenance Manual

SECTION 12—ACCESSORIES

Installing/Removing the Safety Flag

WARNING
The installation of the safety flag onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
NOTE: For this procedure, refer to FIGURE 12.3.
Installing
1. Install the bracket into the accessory tube located on the back of the seat.
2. Install mounting knob to secure the bracket in place. Securely tighten.
3. Install safety flag into bracket.
Removing
1. Remove the safety flag from the bracket.
2. Remove the mounting knob that secures the bracket in place.
3. Remove the bracket from the accessory tube located on the back of the seat.
Safety Flag
Mounting Knob
Bracket
Accessory Tubes
FIGURE 12.3 Installing/Removing the Safety Flag

Installing/Removing/Using the Walker Holder

INSTALLATION WARNINGS
After ANY adjustments, repair or service and before use, make sure that all
attaching hardware is tightened securely.
The installation of the walker holder onto the back of the scooter seat significantly
increases the length of the scooter. When turning the scooter or swiveling the
scooter seat, it is important to take note of this increased length - otherwise, injury
and/or damage to the surrounding property may result.
47
Part No. 1143205 Lynx™L-3 & Lynx L-4