Assembly Instructions - Central Machinery 46813 Assembly And Operating Instructions Manual

nOte: For additional references to the parts listed below, refer to the assembly
diagrams on pages 29 through 37 of this manual.
warning! priOr tO perFOrMing any asseMbly prOcedures, MaKe
sure the 10" table saw is discOnnected FrOM its electrical pOwer
sOurce.
To Mount The 10" Table Saw On A Workbench:
nOte: If the 10" Table Saw is mounted onto a workbench instead of the Leg As-
1.
sembly, the workbench surface must have an opening for sawdust to fall through.
This opening must be as large as the opening in the bottom of the 10" Table Saw
Base (part #1G). A minimum height of 36" from the top of the Base to the floor is
recommended. (see Figure b, and assy. diagram g.)
2. With assistance, set the 10" Table Saw in a desired location on the workbench.
nOte: Make sure the workbench provides a flat, level, sturdy surface capable of
supporting the weight of the 10" Table Saw, tool accessories, and workpieces.
3. Use the four 5/16" mounting holes located at the bottom of the Base (part #1G))
as a template, and mark the two points at which four holes will be drilled through
the workbench. Then, temporarily set the 10" Table Saw aside.
(see Figure b, and assy. diagram g.)
4. With a drill and a 5/16" drill bit (not provided), drill four mounting holes downward
through the top of the workbench.
5. Align the four mounting holes at the Base (part #1G) of the 10" Table Saw with
the four previously drilled holes in the workbench. Then secure the 10" Table Saw
to the workbench, using four 5/16" bolts of appropriate length, two lock washers,
and two nuts (not provided).
To Assemble The Leg Stand:
nOte: Temporarily finger tighten all hardware mentioned in this section until the
1.
Leg Stand is fully assembled.
2. Attach one Long Leg Brace (part #10B) to the lower mounting holes in two Legs
(part #4B), using one Carriage Bolt (part #5B), one Washer (part #3B), and one
Hex Nut (part #2B) for each Long Leg Brace. Repeat the assembly procedure for
the remaining one Long Leg Brace and two Legs.
(see Figure b, and assy. diagram b.)
SKU 46813

asseMbly instructiOns

PAGE 9