Central Machinery 46813 Assembly And Operating Instructions Manual page 21

10" SAW BLADE
(#14-I)
3. Reach into the Saw Blade opening and remove the Blade Nut (part #16-I)) and
Outer Blade Washer (part #15-I). (See Figure R, and Assy. Diagram I.)
4. Place the 10" Saw Blade (part #14-I) on the Arbor Shaft (part #13-I)).
NOTE: Make sure the teeth of the 10" Saw Blade are pointing DOWN toward the
FRONT of the Saw Table. (See Figures R, S, and Assy. Diagram I.)
10" SAW BLADE (#14-I)
5. Replace the Outer Blade Washer (part #15-I) and Blade Nut (part #16-I) securely
on the Arbor Shaft (part #13-I). NOTE: In order to keep the 10" Saw Blade from
turning during this assembly procedure, place a piece of scrap wood on the Saw
Table and against the back sides of the 10" Saw Blade teeth. Then while holding
the scrap wood firmly in place, wrench tighten the Blade Nut onto the Arbor Shaft
to secure the 10" Saw Blade. (See Figures R, S, and Assy. Diagram I.)
SKU 46813
(SAW TEETH POINT DOWN TOWARD FRONT OF SAW TABLE)
SAW TABLE (#17H)
OUTER BLADE WASHER (#15-I)
ARBOR SHAFT (#13-I)
BLADE NUT (#16-I)
SAW TABLE (#17H)
(FRONT)
PAGE 21
FIGURE R
FIGURE S