Central Machinery 46813 Assembly And Operating Instructions Manual page 20

3. Push the Motor (part #7F), with its attached Belt Guard (parts #1F, #4F), forward
and place the V-Belt (part #40-I) on the Motor Pulley (part #5F).
(see Figure p, and assy. diagrams F, and i.)
4. Turn the Height Handle clockwise until it stops.
(see Figure b, and assy. diagram g.)
5. Pull the Motor (part #7F), with its attached Belt Guard (parts #1F, #4F), out un-
til the V-Belt (part #40-I) is taut. Then, securely tighten the two Hex Head Bolts
(part #44-I). (see Figure p, and assy. diagrams F, and i.)
6. Close the hinged Belt Guard (parts #1F, #4F).
(see Figure p, and assy. diagram F.)
To Install The 10" Saw Blade:
1. Turn the Height Handle (part #5G) clockwise until it stops.
(see Figure b, and assy. diagram g.)
2. Unscrew and temporarily remove the Flat Head Screw (part #16H)) located at the
front of the Throat Plate (part #15H)). Then, remove the Throat Plate to expose
the 10" Saw Blade opening. (see Figures Q, r, and assy. diagram h.)
SKU 46813
SAW TABLE (#17H)
THROAT PLATE (#15H)
FLAT HEAD SCREW (#16H)
PAGE 20
Figure Q
reV 04/03