Removing The Back Cover - HP DesignJet 250C Service Manual

Removing the Back Cover

1 Remove the left and right end covers
' pages 6 9 and 6 10.
2 Remove the screws that attach the back
cover to the plotter.
D/A1 size plotters have 2 screws.
E/A0 size plotters have 3 screws.
Torx-20
Reassembling: Before replacing the
screws, ensure that the electronics module
is flush against the inside back of the
plotter.
C A U T I O N
In the following steps, take care not to
damage the parallel port clips.
3 Pull the bottom of the cover slightly back
and out from the plotter.
C4699 90000
4 Lift the cover up, and remove it from the
plotter.
Removal and Replacement 6 33