Removing The Entry Platen - HP DesignJet 250C Service Manual

Removing the Entry Platen

1 Remove the overdrive enclosure ' page
6 46.
2 Disconnect the media sensor cable from
the main PCA (connector labeled
MEDIA).
3 Remove the indicated screw from the
right side plate.
1
6 48 Removal and Replacement
4 Remove the indicated two screws from
the left side plate.
5 Release the indicated entry platen clips
by pushing the bottom front corners of
the entry platen up.
Torx-15
6 Pull the entry platen horizontally out
from the plotter.
Reassembling: See the following procedure.
Torx-20
Torx-15
3
C4699 90000
2