Removing The Overdrive Enclosure - HP DesignJet 250C Service Manual

Removing the Overdrive
Enclosure
230
1 Remove the right end cover ' page 6 10.
250C
330
Remove the spittoon ' page 6 24.
350C
2 Remove the overdrive roller ' page 6 32.
3 Remove the indicated two screws from
the right side plate.
1
2
This illustration shows the configuration
for the DesignJet 230/250C. The removal
procedure for DesignJet 330/350C is
exactly the same except that the spittoon
has been removed to access the indicated
screws.
6 46 Removal and Replacement
4 Remove the indicated three screws from
the left side plate.
Torx-15
5 Lift the overdrive enclosure out from the
plotter.
Reassembling: See following procedure.
Torx-15
3
4
5
C4699 90000