HP DesignJet 250C Service Manual page 100

10 Use the right cam journal to raise the
pinch wheels, and lift the right side of the
drive roller up.
11 Lift the roller out of the plotter.
W A R N I N G
Reassembling: See following procedure.
After reassembling, make sure that you
check the carriage to media distance '
page 7 11
6 42 Removal and Replacement
Reinstalling the Drive Roller
W A R N I N G
In the following procedure, take care
not to injure your fingers if you let the
drive roller snap into place.
C A U T I O N
In the following procedure
D Take care not to damage the media
separator. Don't let it slip under the drive
roller.
D Take care that the edge of the media
separator does not damage the rubber
surface of the drive roller.
1 Flex the media separator upwards and
position the roller behind it and on top of
the pinch wheels.
2 Make sure that the gear on the left side of
the roller is positioned immediately to the
left of the side plate.
C4699 90000