Removing The Right End Cover - HP DesignJet 250C Service Manual

Removing the Right End Cover

1 Remove the top cover ' page 6 7.
330
2 Remove the roll feed assembly ' page 6 8.
350C
3 Remove the pinch wheel lever and screw.
Torx-10
6 10 Removal and Replacement
4 Pull the plotter on/off switch out of the
end cover.
5 Release the three clips at the bottom of
the end cover: first the side clip, then the
front and back clips.
These may be stiff.
B
A
C4699 90000