Removing The Left End Cover - HP DesignJet 250C Service Manual

Removing the Left End Cover

1 Remove the top cover ' page 6 7.
330
2 Remove the roll feed assembly ' page 6 8.
350C
3 Release the three clips at the bottom of
the end cover: first the side clip, then the
front and back clips.
These may be stiff.
B
C4699 90000
C
4 Pull the end cover up, and remove it from
the plotter.
Reassembling: It's not easy to reinstall the
end covers on the plotter. With some practice,
you should learn the knack. As a guide, before
you replace an end cover, take a look at the
various clips on its inside, and identify where
A
they fit on the plotter.
Make sure that the primer plunger is installed
properly when reinstalling the end cover.
Removal and Replacement 6 9