Connector Cable - HP DesignJet 250C Service Manual

8 Pull the electronics module to the right,
in order to easily access the connectors.
9 Disconnect all cables from the visible part
of the main PCA.
B
Reassembling:

Connector Cable

330
350C
6 14 Removal and Replacement
10 Pull the electronics module further to the
right and out of the plotter.
Reassembling:
11 If you are changing the electronics module
for a new one, remove the DRAM SIMM(if
installed) from the old module and install
it into the new one. Refer to Chapter 9
before installing the ROM SIMM from the
C
old module into the new module.
Calibrations:
A
Clip
Reassembling:
'
'
C4699 90000