Wave Card Load - Yamaha SY85 Owner's Manual

[SHIFT]+[UTILITY] → [CARD]
card slot.
To
250
WAVE EDIT MODE /

WAVE CARD LOAD

Loads all samples from a pre-programmed card plugged into the WAVEFORM
WAVE`Card`Load``````````````````````````
`````````````````Card````¥`Volatile`Mem.
F1 F2
CS1 CS2
Range: Volatile, Non-vol.
Controls: [CS7], [-1] [+1], Dial
Use [CS7] to select the type of memory to which the data is to be stored
(see "Wave Memory Expansion" on page 285 for additional information about
the memory types).
Press [ENTER/YES] to begin the card load procedure. The following confir-
mation display will appear:
WAVE`Card`Load````````````Are`you`sure`?
`````````````````Card````¥`Volatile`Mem.
Press [ENTER/YES] again to confirm that you want to go ahead with the
card load operation, or press [EXIT/NO] to cancel.
When the data has been loaded , "Completed!" will appear briefly on the
display.
CARD
F3 F4 F5
CS3 CS4 CS5
F6 F7 F8
CS6 CS7 CS8