Load - Yamaha RX11 Owner's Manual

Verify takes about 20 seconds. If no data errors are en-
countered, the LCD panel will read "VERIFY OK". The
cassette recorder can be stopped at this point. If an error
is encountered, however, the display will read "VERIFY
ERROR". If this happens, return to the cassette control
mode by pressing the CASSETTE button and try saving the
data again. The SAVE/VERIFY, LOAD, +1/YES or –1/NO
buttons can also be used to return to the cassette control
m o d e .
Save Data to Cassette and Verify
Start cassette recorder in RECORD mode.
Stop cassette recorder, rewind to beginning of saved
file to VERIFY.
Stop cassette recorder
The verify function can be accessed directly, without going
through the save operation, by responding –1/NO (or
SAVE/VERIFY) to the "SAVE TO TAPE?" prompt. The
save and verify operations can be interrupted at any time by
pressing the CASSETTE button. The cassette control mode
can be reentered from any cassette operation prompt by
pressing the CASSETTE button. The cassette control mode
is also exited by pressing the CASSETTE button.

Load

To load data from a cassette tape into the RX11 memory,
first enter the cassette control mode by pressing the CAS-
SETTE button while holding down the FUNCTION button.
When the LCD panel presents you with the "CASSETTE
CONTROL" message, press the LOAD button. The LCD
panel will respond with "LOAD FROM TAPE?". Press the
+1/YES button to continue, or the –1/NO button to return
to the cassette control mode. If the +1/YES button is pressed,
the LCD panel will respond with "LOAD READY?". Make
sure that the data cassette is rewound to the beginning of
the file you wish to load, press the +1/YES button then
start the cassette player in the playback mode to begin
the load operation. While the RX11 is loading the data the
display will read "LOAD EXECUTING". If the load opera-
tion is completed and no errors are detected, the RX11 will
return directly to either the song or pattern mode. If a
load error is detected the LCD display will read "LOAD
ERROR!" In this case return to the cassette control mode
by pressing the CASSETTE button (or the SAVE/VERIFY,
LOAD, –1/NO or +1/YES buttons) and carry out the load
process again.
Load Data from Cassette
Position cassette at beginning of file to LOAD.
Start cassette recorder in PLAY mode.
22
Return to SONG or PATTERN mode.