1: Copy Pattern - Yamaha SY85 Owner's Manual

[PATTERN] → [JOB] → [MENU] → 1:Copy Pattern → [ENTER/YES]
want to make minor changes to an existing pattern while retaining a copy of the
original pattern data. It is also possible to append one pattern to another, and copy
the result to a new pattern number.
From (Source and append patterns)
To
202
PATTERN EDIT MODE /

1: COPY PATTERN

Copies all pattern data from one pattern to any other. This can be handy if you
PTN`JOB`Copy`Pattern``````From``````To``
```````````````<Funk1``V>`I00+`***``I00`
F1 F2
CS1 CS2
Range: 00 ... 99
Controls: [CS6], [CS7], [-1] [+1], Dial
Range: 00 ... 99
Controls: [CS8], [-1] [+1], Dial
Use [CS6] to select the "From" or source pattern number (0 ... 99), [CS7]
to select a pattern to be appended to the end of the of the first pattern (leave
this parameter set to "***" if you do not want to append a pattern), and [CS8]
to select the "To" or destination pattern number. The name of the currently
selected "From" or "To" pattern is shown between parentheses on the lower
display line, depending on which parameter the cursor is positioned below.
Press [ENTER/YES] to begin the copy procedure. The following confirma-
tion display will appear:
PTN`JOB`Copy`Pattern``````From``````To``
Are`you`sure`?`<Funk1``V>`I00+`***``I00`
Press [ENTER/YES] again to confirm that you want to go ahead with the
copy operation (which will overwrite all data in the "To" pattern number), or
press [EXIT/NO] to cancel.
When the pattern data has been copied, "Completed!" will appear briefly on
the display.
PATTERN JOB
F3 F4 F5
CS3 CS4 CS5
F6 F7 F8
CS6 CS7 CS8