Installing The Back Page Imprinter And Ink Cartridge - Kodak Ngenuity 9000 Series User Manual

Installing the back
page imprinter and
ink cartridge
A-61662 April 2010
To ensure proper installation of the ink cartridge, install the imprinter
cartridge before installing the imprinter into the scanner. Be sure the ink
cartridge is properly seated.
1. Remove the imprinter and ink cartridge from the box.
2. Remove the protective tape from the ink cartridge.
3. Move the carriage to the center position.
4. Hold the ink cartridge holder with one hand and place the ink
cartridge (bottom end first) into the holder and snap into place.
5. Turn off the scanner and power down the PC.
6. Open the back page imprinter door located in the back of the scan-
ner.
7. Install the imprinter with the ink cartridge holder facing the bottom of
the scanner, inserting the spring-loaded locating pin into the corre-
sponding hole found in the back page assembly.
8. Hand-tighten the thumb screw located on the left side of the
imprinter into the corresponding hole found in the scanner's back
page assembly.
Center position
B-5