Rear View - Kodak Ngenuity 9000 Series User Manual

Rear view

1
A-61662 April 2010
2
3
4
1 Imprinter door — provides access to the optional imprinter for
installation and maintenance. It requires an additional 3.5 inches
(9 cm) of clearance to open fully.
2 Straight pass-through door — allows you to use the straight
pass-through feature. When the door is open, documents are fed
through this exit. This is useful for scanning thick or stiff
documents. It requires an additional 3.5 inches (9 cm) of clearance
to open fully. Only open this door when you are using the straight
pass-through feature, if the door is opened while scanning in rotary
mode, a document jam will occur.
3 SCSI connector — connects an optional SCSI cable (cable and
SCSI card are not provided).
4 USB connector — connects the USB cable to the scanner and
host PC.
5 Fan — for cooling the scanner. The fan is part of the scanner's
power supply. Make sure to properly vent the scanner for optimal
performance.
6 Power connector — connects the power supply to the scanner.
7 Power switch — turns the scanner on (I) and off (O).
8 Foot — four rubber feet allow for clearance below the scanner.
9 Intake vent (on side) — used for drawing air in for cooling. Be sure
to position the scanner in such a way that the intake vent is not
blocked.
NOTE: Be sure to maintain an addition 4-5 inches (10-13 cm) of
additional clearance at the front, back and sides of the scanner
for proper ventilation.
8
5
6
7
9
1-7