Kodak Ngenuity 9000 Series User Manual page 37

Conflicting Controls
Single Page Scan
VRS Administration Utility -
Warning tab
On Errors QC Mode
Every Page QC Mode
First Page QC Mode
Deskew and Auto Crop
Image Rotation of 90, 180, or
270 degrees
Auto Orientation
Picking Rectangle
Automatic Color Detection
Advanced Clarity
4-8
The Very Long Document option does not support the simultaneous
use of some other options offered through VRS ImageControls and
Direct Drivers. Following is a table that identifies those other controls as
well as how the scanner and software handle the conflict when you
attempt to use them together.
The scan is terminated and an error message is displayed. Very
Long Document is not supported with single-page scanning. Use
the batch scan command.
The document is scanned ignoring the warning conditions that are
set. No error message is displayed.
The document is scanned ignoring the On Errors QC Mode options
that are set. No error message is displayed.
The scan is terminated and an error message is displayed.
The scan is terminated and an error message is displayed.
The document is scanned ignoring the Deskew and Auto Crop
options that are set. No error message is displayed.
Do not select rotation options if scanning using Very Long
Document.
The scan is terminated and an error message is displayed.
For best results, do not use Very Long Document and Picking
Rectangle at the same time.
For best results, do not use Very Long Document and Automatic
Color Detection at the same time.
For best results, do not use Very Long Document and Advanced
Clarity at the same time.
Ignore Holes/Ragged Edges — click Enable to adjust the entry and
exit sensors so they ignore holes on the leading or trailing edge of a
document (e.g. three-hole punched paper), that may cause the scanner
to detect false starting or trailing edges of a document. If you are
receiving Page Sensor or Peripheral Malfunction errors, enable this
feature and adjust the value until the error disappears.
This option can be set using a measurement in inches or millimeters
with a range of 0.0 to 1.7 inches (0 to 43 mm). Set Ignore Holes/
Ragged Edges to a width slightly larger than the holes in the paper (or
whatever may be causing the false detection of the leading or trailing
edges of a document).
NOTE: Enabling Ignore Holes/Ragged Edges may reduce scanning
throughput.
Front/Back Negative Image Enable — allows you to request a black
and white/grayscale image when scanning in black and white or
grayscale only. This control is not supported when scanning in color.
Resolution
A-61662 April 2010