HP dx7300 Technical Reference Manual page 170

Error Messages and Codes
A.19 SCSI Interface Error Messages (65xx-xx, 66xx-xx,
67xx-xx)
Message
6nyy-02
6nyy-03
6nyy-05
6nyy-06
6nyy-07
6nyy-08
6nyy-09
6nyy- 1 0
6nyy- 1 1
6nyy- 1 2
6nyy- 1 3
6nyy- 1 4
6nyy- 1 5
6nyy- 1 6
6nyy- 1 7
6nyy- 1 8
6nyy-21
6nyy-24
6nyy-25
6nyy-30
6nyy-31
6nyy-32
n = 5, Hard drive
= 6, CD-ROM drive
= 7, Tape drive
yy = 00, ID
= 03, Power check
= 05, Read
= 06, SA/Media
= 08, Controller
= 23, Random read
= 28, Media load/unload
A-18
SCSI Interface Error Messages
Probable Cause
Drive not installed
Media not installed
Seek failure
Drive timed out
Drive busy
Drive already reserved
Reserved
Reserved
Media soft error
Drive not ready
Media error
Drive hardware error
Illegal drive command
Media was changed
Tape write-protected
No data detected
Drive command aborted
Media hard error
Reserved
Controller timed out
Unrecoverable error
Controller/drive not connected
Table A-18
Message Probable Cause
6nyy-33 Illegal controller command
6nyy-34 Invalid SCSI bus phase
6nyy-35 Invalid SCSI bus phase
6nyy-36 Invalid SCSI bus phase
6nyy-39 Error status from drive
6nyy-40 Drive timed out
6nyy-41 SSI bus stayed busy
6nyy-42 ACK/REQ lines bad
6nyy-43 ACK did not deassert
6nyy-44 Parity error
6nyy-50 Data pins bad
6nyy-51 Data line 7 bad
6nyy-52 MSG, C/D, or I/O lines bad
6nyy-53 BSY never went busy
6nyy-54 BSY stayed busy
6nyy-60 Controller CONFIG- 1 register fault
6nyy-61 Controller CONFIG-2 register fault
6nyy-65 Media not unloaded
6nyy-90 Fan failure
6nyy-91 Over temperature condition
6nyy-92 Side panel not installed
6nyy-99 Autoloader reported tape not loaded properly
www.hp.com Technical Reference Guide