Memory Module Location - HP C100/110 Owner's Manual

Perform the following steps to add memory modules to your workstation.
1 Remove the main tray assembly according to the directions in "Removing the
2 Use Figure 37 to locate the memory modules on the CPU Assembly.
Figure 37
NOTICE: Memory slots must be filled in order from 0A and 0B through 3A and 3B.
Main Tray Assembly" earlier in this appendix.
0A
2A
0B
2B
1A
3A
1B
3B
Rear of Main Tray

Memory Module Location

This workstation has 8 memory slots, labeled 0A, 0B through 3A, 3B. The mem-
ory configuration is 32 MB to 512 MB installed in pairs of 16 MB or 32 MB
memory modules.
Memory modules must be installed in pairs of equal capacity.
Always install the largest capacity memory modules in the lowest numbered
memory slots.
For example, if you have a pair of 16 MB memory modules and a pair of 64 MB
memory modules, first install the pair of 64 MB memory modules in slots 0A
and 0B, then install the 16 MB modules in slots 1A and 1B.
Changing Your Workstation's Hardware Configuration
Installing Additional memory
145