Connecting To The Scsi Ports; System Scsi Port Connection; Rear Panel Scsi Connectors Without Terminators - HP C100/110 Owner's Manual

Connecting to the SCSI Ports

This section describes how to connect to the system SCSI ports (single-
ended and fast, wide).

System SCSI Port Connection

The system contains two (2) SCSI connectors:
•
•
Figure 47 shows the two SCSI connectors. SCSI cables connect to these
ports with a high-density thumb screw connector.
Figure 47
It is not necessary to put a terminator on empty SCSI connectors on
NOTICE:
the backpanel. However, the last device connected to the SCSI bus
must be terminated with a SCSI terminator. All of the devices listed
ship without terminators. If you do not already have a SCSI
terminator, you must order a C2905A, 68-pin terminator for the fast,
wide SCSI bus, or a C2904A, 50-pin high density terminator for the
single-ended SCSI bus from Hewlett-Packard.
System Single-Ended SCSI Connector
System Fast, Wide SCSI Connector

Rear Panel SCSI Connectors without Terminators

Single-ended SCSI
Fast, Wide SCSI
SCSI Connections
Connecting to the SCSI Ports
173