Installing A Cd-Rom Or Dds Tape - HP C100/110 Owner's Manual

Changing Your Workstation's Hardware Configuration
Installing Storage Devices
2 From the rear of the storage tray, line up the disk slides on the CD-ROM or DDS
CD-ROM or DDS Tape Drive
Cable Routing Label
Figure 26
3 Push the storage device in until the locking tabs snap into place.
4 Connect the single-ended SCSI-2 data cable and the power cable to the drive.
5 Proceed to the section entitled Replacing the Storage Tray.
126
tape drive with the position 1slots in the storage tray chassis, and slide it into
place, as shown in Figure 26.

Installing a CD-ROM or DDS Tape

Refer to the cable routing label on the storage tray.