Configuration Port; Control Buttons - Extron electronics DXP DVI User Manual

Configuration Port

c

Control Buttons

Primary Functions
Action:
Indication:
Secondary Functions
Action/
I/O Grouping
indication:
Action 1:
Port
Action 2/
configuration
indication:
Front panel
Action:
locks
d
Secondary functions ( • ):
Select a global preset (see
•
Output 1 only: With the Input 1 button, places the switcher in I/O grouping
•
mode (see "I/O Grouping" on page 32).
Mute and unmute an output (see
•
Outputs" on page 36).
Config port — This RS-232 port is an alternative to the Remote RS232/RS422
connector on the DXP rear panel (see "
page 9 for a description). The port (RS-232 only) can be used for system configuration
and control via SIS commands or the control software. To connect to the Config port,
see "RS-232 Config port (front
The following table summarizes the primary and secondary functions of the four
control buttons.
ENTER
Select preset
Save changes.
mode.
Blink: Save Blink: Save preset.
needed Lit: Recall preset.
Select group 1. Select group 2.
Select Configuration Mode
Select 9600 baud. Select 19200 baud.
Blink: Selected Blink: Selected
With Video and
Audio, select lock
mode 2 or toggle
between modes 0
and 2.
Enter button — The Enter button does the following:
Primary functions (❏):
Saves changes that you make on the front panel.
❏
Indicates that a potential tie has been created but not saved.
❏
Indicates that a global preset has been selected to be saved or recalled but that
❏
the preset action has not been accomplished.
DXP DVI, DXP DVI Pro, and DXP HDMI Series • Operation
"Saving and Recalling Presets" on page 29).
"Muting and Unmuting Video and Audio
g
Remote RS232/RS422
panel)" on page 11.
PRESET
VIEW
Select view
mode.
View the selected
mode.
Select group 3.
Select 38400
baud.
Blink: Selected
connector" on
ESC
Cancel or
escape.
Blinks once.
Select group 4.
Select 115200
baud.
Blink: Selected
15