Uploading Html Files - Extron electronics DXP DVI User Manual

Uploading HTML Files

You can create customized HTML pages for the DXP to display. The HTML Files List
window (shown below) provides a way to view the contents of the DXP file system and to
upload custom HTML pages to the switcher.
Figure 83.
NOTES:
Upload HTML pages as follows:
1. Connect the PC to the DXP via the rear panel Remote RS232/RS422 port, the front
panel Config port, or the Ethernet port.
2.
Start the Matrix Switcher Control Program and connect to the DXP switcher (see
steps 1 through 4 under
3. From the
opens.
4. Click the
Extron Server window opens.
5. Navigate to the folder where you saved the HTML files and select them.
NOTES:
6. Click the
7. Click the
8. Click the
HTML Files List Window
• The file listed in figure 83 is shown for example only and may not be present
on your switcher.
• The HTML Files List window is for inserting your own HTML pages. This
is not the window used to replace the firmware that controls all switcher
operation (see "Updating the
firmware).
• The following characters are invalid or not recommended in file names:
+ ~ , @ = ` [ ] { } < > ' ' " " ; : | \ ?
"Using the
menu, select
Tools HTML File Manager
Pick File(s)to Load to Server
• To select multiple files, hold the <Ctrl> key while you click on the desired
files.
• If you want one of the HTML files that you created to be the default
start-up page, name the file "index.html." The DXP switcher looks for
that file name when you first connect to it using an Internet browser.
button. The file uploading process may take a few minutes.
Open
button to confirm the upload.
Update
button to exit the HTML Files List window.
Close
DXP DVI, DXP DVI Pro, and DXP HDMI Series • Matrix Software
Firmware" on page 85 to update the
and
Software" on page 73 for the procedure).
. The HTML Files List window
button. The Select Files to Upload to
.
{space}
87