Power connector
Description
Power connector
Before removing the power connector cable, remove the following components:
1.
Battery (see
2.
Service door (see
3.
Hard drive (see
4.
Optical drive (see
5.
Keyboard (see
6.
Top cover (see
Remove the power connector:
1.
Position the computer right-side up.
2.
Disconnect the power connector cable (1) from the system board.
3.
Lift the power connector (2) away from the clips built into the base enclosure.
Reverse this procedure to install the power connector.
66
Chapter 4 Removal and replacement procedures
Battery on page
46)
Service door on page
Hard drive on page
Optical drive on page
Keyboard on page
55)
Top cover on page
58)
47)
48)
50)
Spare part number
641137-001