Assigning The Stack Ip Address; Avaya Default Settings - Avaya P334T-ML Quick Start Manual

Multilayer stackable switch

Hide thumbs Also See for P334T-ML:

Table of Contents

Prepare for Configuration

4. Type the default password root when prompted and press Enter.

- The P333R-N(super)# prompt appears

N is the number of the switch in the stack.

Assigning the Stack IP Address

Tip:

Commands are shown as follows: set interface inband;

Tip:

parameters which you need to enter are shown in <> as follows: <vlan>

1. Type set interface inband <vlan> <ip_address> <netmask>, replacing

<vlan>, <ip_address> and <netmask> with the VLAN, IP address and net mask of the

stack and press Enter.

2. At the P333R-N(super)# prompt, type reset and press Enter to reset the stack.

3. After the Reset, perform login again as described above.

- The P333R-N(super)# prompt appears.

4. Type set ip route <destination> <gateway>, replacing <destination> and

<gateway> with the destination and gateway IP addresses.

5. Press Enter to save the destination and gateway IP addresses.

If you wish to change the default parameters shown and configure the mandatory parameters,

we recommend that you use the Command Line Interface (CLI).

For further information, please refer to Chapter 6 of the Avaya User's Guide.

The default settings for the Avaya switch and its ports are determined by the Avaya firmware.

These default settings are subject to change in newer versions of the Avaya firmware. See the

P330-ML Release Notes for the most up-to-date settings.

28 Quick Start for Hardware Installation: Multilayer Stackable Switch

Table 6: Default Switch Settings 1 of 2

Function

IP address

BootP mode

Default Setting

149.49.32.134

Never

1 of 2

Table of Contents