Turning The Appliance Off; Menu Settings; Descaling; Setting The Language - DeLonghi ESAM04.350 Instructions For Use Manual

Danger of burns!
during rinsing, a little hot water comes out of the coffee spouts
and is collected in the drip tray underneath. avoid contact with
splashes of water.
• To turn the appliance on, press the
The message "heating up Please wait" is displayed.
after heating, the message "rinsing" is displayed, together with
a progress bar which gradually fills as preparation progresses.
as well as heating the boiler, the appliance also heats the
internal circuits by circulating hot water.
The appliance is at temperature when the message indicating
the taste and quantity of coffee appears.

TURNING THE APPlIANCE OFF

each time the appliance is turned off, it performs an automatic
rinse cycle which cannot be interrupted.
Important!
To avoid damaging the appliance, always press the
button to turn off.
Danger of burns!
during rinsing, a little hot water flows from the coffee spouts
(only if coffee has been made).
avoid contact with splashes of water.
To turn the appliance off, press the button
appliance performs a rinse cycle then goes off.
Please note:
if the appliance is not used for an extended period, place the
main switch in the 0 position (fig. 6).
never place the main switch in the 0 position while the
appliance is on.
no rinse is performed if no drinks with coffee have been made
while the machine has been on.

MENU SETTINGS

When you access the settings menu by pressing the MENU button, the
following menu items can be selected: descale, Set language, energy
saving, adjust time, auto-start, auto-off, Set temperature, Water
hardness, Statistics, default values.

Descaling

For instructions on descaling, see page 16.

Setting the language

To modify the language of the display, proceed as follows:
1. Press the MENU button to enter the settings menu.
2. Press the or button until "Set language" is displayed;
3. Press the OK button;
4. Press the or button until the required language is
displayed;
5. Press the OK button to confirm;
6. Press the ESC button exit the menu.

Energy Saving

button (fig. 5).
use this function to enable or disable "energy saving" mode.
When enabled, the function reduces energy consumption in
compliance with european regulations.
To enable or disable the function, proceed as follows:
1. Press the MENU button to enter the settings menu.
2. Press the or button until "energy saving" is displayed;
3. Press the OK button. "disable?" is displayed (or "enable?"
if the function has already been disabled).
4. Press the OK button to disable or enable the function or
the ESC button to exit the menu.
When the function is active, if the machine is not used for
about 1 minute, "energy saving" is displayed.
Please note!
• To exit " Energy saving" mode, press any button, then press
the button corresponding to the drink you want to make.
• A few seconds may elapse between " Energy saving" mode
and delivery of the first drink; "Preparation underway..." is
displayed.

Adjust time

(fig. 5). The
To adjust the time on the display, proceed as follows:
1. Press the MENU button to enter the settings menu.
2. Press the or button until "adjust time" is displayed;
3. Press the OK button. The hours flash on the display;
4. Press the or button to change the hours;
5. Press the OK button to confirm. The minutes flash on the
display;
6. Press the or button to change the minutes;
7. Press the OK button to confirm;
8. Press the ESC button to exit the settings menu.
Please note!
The time is displayed when the appliance is in stand-by or
energy saving mode. if the time has not been adjusted, "0:00"
flashes on the display.

Auto-Start

you can set the auto-start time in order to have the appliance
ready at a certain time (for example in the morning) so you can
make coffee immediately.
Please note!
To enable this function, the time must be set correctly.
To enabled auto-on, proceed as follows:
10