Cleaning The Milk Container; Cleaning The Hot Water/Steam Nozzle; Descaling - DeLonghi ESAM04.350 Instructions For Use Manual

PuSh symbol fully in until it clicks into place.
Please note!
8. once inserted, make sure the two red buttons have
snapped out.
9. replace the drip tray and waste coffee
container.
10. Close the service door.

Cleaning the milk container

Clean the milk container each time you prepare milk as
described below:
1. remove the lid of the
milk container.
2. remove the milk
spout and intake
tube.
3. Wash all the
c o m p o n e n t s
thoroughly with
hot water and mild
washing-up liquid.
All components are
dishwasher safe,
placing them in the
top basket of the
dishwasher.
4. Make sure there are
no milk residues left
inside the holes.
5. Check that the intake
tube and spout are not clogged with milk residues.
6. replace the milk spout and intake tube.
7. replace the milk container lid.
If the infuser is difficult to insert,
you must first adapt it to the right
dimensions by pressing it
forcefully from the bottom and
top as shown in the figure.

Cleaning the hot water/steam nozzle

each time you prepare milk, clean the nozzle with a sponge to
remove milk residues from the gaskets (fig. 24).

DESCAlING

descale the machine when the message "deSCale" flashes on
the display.
Important!
descaler contains acids which may irritate the skin and eyes.
it is vital to respect the manufacturer's safety warnings given on
the descaler pack and the warnings relating to the procedure to
follow in the event of contact with the skin and eyes.
Please note!
use de'longhi descaler only. under no circumstances should
you use sulphamic or acetic based descalers. Their use
invalidates the guarantee.
Failure to descale the appliance as described above also
invalidates the guarantee.
1. Turn the machine on.
2. Press the MENU button to enter the settings menu. Press
the or button until "descale" is displayed;
3. Press the OK button to confirm: The message "add descaler
Press OK" is displayed.
4. Before confirming empty the water tank (a10) completely.
Pour the descaler (a23) diluted with water (respecting the
proportions indicated on the descaler pack) into the water
tank and replace the tank in the appliance.
Important! Danger of burns
hot water containing acid flows out of the hot water spout.
avoid contact with splashes of water.
5. Place an empty container with a minimum capacity of 1.5
litres under the hot water spout.
6. Confirm with the OK button.
7. After confirming by pressing OK, the message "Descale
underway" is displayed. The descale programme starts
and the descaler liquid comes out of the water spout.
The descale programme automatically performs a series
of rinses and pauses to remove limescale deposits from
inside the machine.
After about 30 minutes, the message "Rinsing FILL TANK" is
displayed.
8. The appliance is now ready for rinsing through with
clean water. remove the water tank, empty, rinse under
running water, fill with clean water and replace. "rinsing
Press OK" is displayed.
9. empty the container used to collect the descaler solution
and replace it under the cappuccino maker.
16